Thema: enigmalight: Segmentation fault

Hallo zusammen,
unter openatv 6.2 lief alles gut. Habe das System mit openatv 6.3 neu aufgesetzt.
Seit dem bleiben die LEDs dunkel.
starte ich auf der Konsole "enigmalight" folgt:

Code:

EnigmaLight (c) 2014 Speedy1985 and Oktay Oeztueter.
(Based on Boblight (c) 2009 by Bob Loosen)

[InitLog]                       start of log /home/elight-addons/.enigmalight/enigmalight.log
[CConfig::LoadConfigFromFile]   Opening /etc/enigmalight.conf
[CConfig::CheckConfig]          checking config lines
[CConfig::CheckConfig]          config lines valid
[CConfig::LoadConfigFromFile]   Opening /etc/enigmalight.conf
[CConfig::BuildConfig]          building config
[CConfig::BuildConfig]          built config successfully
[main]                          Start device 1 from 1
[CDevice::Process]              ambilight: starting with output "/dev/ttyUSB0"
[CDevice::Process]              ambilight: setting up
[CEnigmaLight::SetColorSequence]Set colorsequence to RGB
[CGuiServer::Process]           Start GuiServerset adjust 0 0 0
 1
[CGuiServer::Process]           Opening listening socket for Enigma2 GUI on 127.0.0.1:6767
[CFlagManager::SetVideoGamma]   Gamma not set, using 2.2 since this is default for video
[CMainLoop::Process]            Starting grabber..
[CGrabber::Setup]               Lights: 144, Cluster leds: 1 as one led
[CGrabber::Setup]               Channels: 432
[CGrabber::Setup]               Interval: 0.10
Segmentation fault

Kann mir da jemand helfen?

Nicht gelöst, stattdessen funktioniert aber boblight.